Discussion of Tachikoma eye modeling

• 

• At first I didn't realize the top half was through and thought there were three 30 degree slopes.

  • I didn't know how to fix it, so I wrote on Twitter and they told me.

• 2/12

  • https://twitter.com/Nikujin_29/status/1360058095624331267
    • - Tile Clip - T Pipe - Side Stud
  • The structure of the part that is visible on the outside seems to be correct; it may take some trial and error to determine where to grow the T-shape from.
    • 
  • In fact, it is possible that the three eyeballs are connected to each other and not to the others, and that they are stopped by pressing down from above...
  • Hmmm, narrow...
    • 
  • I don't have enough material to try it, but this would just barely fit in a 2×3 gap.
    • - Tile Clip - Clip Bar - T Type Pipe
  • Stable without tape!
    • 

2/13

• I had only bought two sets last year, so I had to do some trial and error with what parts I could find. It's more severe than I thought. ......

  • 
  • https://twitter.com/Nikujin_29/status/1360539418285625345?s=20
• I see, as for the sides, you combine a 1×1 panel that goes through with a block that has a concave center of studs so that the pipe can go all the way in. - Recessed studs - Open studs - T-pipe
• Is this the black bar growing sideways from the center bar? I don't have one and will buy one.
  • 
    • Bar 1L - 1 x 1 Round Plate

2/15

• I'm not sure if I'm getting the right response because I feel like I've twisted it up quite a bit. ......

• That's what the black bars are for. I haven't tried it because I don't have it on hand, but I have a feeling you could do something similar with two arm-shaped clip bars!

  • - Side Stud - Double Clip Bar
• Hmmm, I might not be able to reach it as it is.
  • 
• I added another one and it connected at least once...
  • - Double Clip Bar

2/16

• Sorry!

• I know it sounds like I'm in the wrong place, but I just bought a few more sets today and I've been playing around with them, and I think I've got a good set up, so I'll share it with you!

• I personally want to make it right because it's not a weirdly elaborate assembly and it's reasonably strong lol.

  • 

This page is auto-translated from /nishio/タチコマの目の造形議論 using DeepL. If you looks something interesting but the auto-translated English is not good enough to understand it, feel free to let me know at @nishio_en. I'm very happy to spread my thought to non-Japanese readers.